USB charger - 3-port built-in, 112W, 12-24V, blue

Why is it useful?

• High performance: up to 2× PD (max. ~45 W/port) + QC 3.0 (max. ~22.5 W), total up to ~112 W*.
• Energy efficient: the on/off switch disconnects the ports when idle.
• Designed for outdoor environments: rubber-covered front panel, splash and dust resistant panel.
• Wide compatibility: 12/24 V systems and all USB gadgets (phone, tablet, camera, PowerBank, GPS).
• Easy installation: standard Ø 30 mm (1.18”) hole, can also fit into a factory cigarette lighter socket.

Main features

Ports:

• USB-C PD 3.0 ×2 – typical PDO: 5/9/12/15/20 V (device dependent), max. ~45 W/port
• USB-A QC 3.0 ×1 – 5 V/3 A, 9 V/2 A, 12 V/1.5 A (max. 18–22.5 W)
• Input: 12–24 V DC (car/boat/motorcycle/ATV/RV)
• Protection: overvoltage, overcurrent, overheating, short circuit (smart IC)
• Design: recessed mounting, LED light ring, rubber protective cap, mountable with panel nut
• Technical data (approximate)
• Performance: total up to ~112 W*
• Mounting hole: Ø ~30 mm (1.18")
• Mounting depth: ~62 mm (total length), front panel edge ~52 mm (body length)
• Operating voltage: 12 V / 24 V
• Connections: quick connectors / spade terminals for wiring
• * The peak value depends on the capacity of the device, cable, and the 12/24 V side of the vehicle; for maximum load on a 12 V system, a ≥15 A fuse and appropriate wire gauge are recommended.

Installation – quick guide

• Select a Ø 30 mm panel hole (or use the cigarette lighter socket location).
• Insert the module, tighten the fixing nut.
• +12/24 V → fuse → switch → module +; – → ground. Pay attention to polarity.
• Turn it on, check the LED ring and charging function.

Note

Not submersible in water; the rubber cover protects against splashes and dust.
PD/QC fast charging works with devices that support the control protocol (the cable must also support PD/QC).